Skip to content
Phuket Dyno by Phuket Garage

Kamala, Phuket · Daily 08:00–20:00, by appointment

Motorcycle dyno & ECU tuning in Phuket

We put your bike on the rollers, measure what it really makes, and rewrite the map inside its own ECU until the fuelling suits your exhaust, your fuel and this heat. You ride home with the before-and-after sheet.

Tools
Woolich Racing · KESS3
Stock file
Read, kept, reversible

Sample sheet — illustration, not a customer bike

0 20 40 60 80 100 12 13 14 15 3k 4k 5k 6k 7k 8k 9k 10k 11k ENGINE SPEED, RPM HP · NM AT THE WHEEL AIR / FUEL
rpm
10,000
hp
79.2 → 82.7
Nm
56.4 → 58.9
AFR
13.1 → 13.1

What we do

Measure first. Then change only what the sheet says.

Dyno power run

Three full-throttle pulls on the rollers. You see what the bike really makes at the rear wheel and whether its fuelling is healthy.

Time
About 1 hour
Price
Quoted on WhatsApp
How it works

Custom ECU remap on the dyno

A map written for your bike, your exhaust and the fuel you buy here — measured before, corrected cell by cell, measured again.

Time
Half a day to a full day
Price
Quoted on WhatsApp
How it works

Feature flash

ECU settings changed without a full fuel map: a fan that starts earlier, a limiter, a quickshifter switched on, a fault code from a removed exhaust valve.

Time
1–3 hours
Price
Quoted on WhatsApp
How it works

Why bikes here need it

The factory map was not written for your bike as it is now.

A manufacturer writes one calibration to pass emissions and noise tests in dozens of countries. It runs lean where the test looks, cuts fuel hard on a closed throttle, and leaves the flat spots and the jerky pick-up every rider knows. That is the starting point, before anyone touches the bike.

  • Exhaust and filter changes. Almost every big bike in Phuket has a slip-on or a full system. The engine now flows more air than the map expects, so it runs leaner still, most of all in the mid-range.
  • Heat. Thirty-plus degrees and slow traffic. Fan thresholds and fuelling written for a European spring are not ideal here.
  • Fuel. Gasohol 91, 95 and E20 behave differently from the fuel the bike was calibrated on. We tune on what you actually put in the tank.
  • Restrictions. Limiters and throttle tables that hold the bike back in certain gears are settings in the ECU. Where they can be changed, we show you what they cost first.

None of that is guesswork on a dyno. The baseline run shows where the fuelling is off, and the remap corrects exactly those places.

How a tuning day runs

Six steps, and the first three change nothing.

  1. 01 / 06

    You send the bike’s details

    Make, model, year and what is fitted. We check the ECU against the tools and tell you whether it is done through the diagnostic plug or on the bench.

  2. 02 / 06

    Check-in

    Chain, rear tyre, leaks and stored fault codes. Anything that would spoil the numbers or endanger the bike is dealt with first.

  3. 03 / 06

    Baseline runs

    The bike goes on the rollers as it arrived. Power, torque and air/fuel ratio are recorded so there is something honest to compare with.

  4. 04 / 06

    Stock file saved

    The original contents of the ECU are read and archived. From here on everything can be undone.

  5. 05 / 06

    Mapping

    Fuel is corrected against the measured air/fuel ratio across revs and throttle positions. Ignition, throttle maps and the agreed settings follow, where the ECU allows it.

  6. 06 / 06

    Verification runs

    The new map is run again until the trace sits where it should. You get the before-and-after sheet and we walk you through it.

The tools

Two ways into the ECU, so most bikes have one.

Japanese bikes first

Woolich Racing

Flash-tuning software built for motorcycles. It opens the fuel, ignition and throttle maps of Honda, Yamaha, Kawasaki and Suzuki ECUs, plus selected BMW and Ducati models, and logs air/fuel ratio while the bike runs so the map is corrected from measurements.

Woolich Racing tuning in Phuket

European bikes and the rest

Alientech KESS3

A professional ECU programmer that reads and writes through the diagnostic plug, or directly on the bench when the plug is locked. It reaches BMW, Ducati, Triumph, KTM, Husqvarna and Aprilia ECUs, and the Japanese ones Woolich does not cover.

KESS3 motorcycle tuning in Phuket

Bikes we tune

Pick your make.

All makes and models

Support depends on the exact model, year and ECU. Send us those three and we confirm before you book.

Before you come

A bike has to be healthy to be measured.

  • Chain and sprockets

    Adjusted, lubricated, not worn out. A tired chain can let go at full power.

  • Rear tyre

    Good tread, correct pressure, no cuts. A road tyre grips the roller far better than a knobbly.

  • No leaks

    Oil, coolant or fuel on the rollers ends the session.

  • Your usual fuel

    At least half a tank of what you normally buy. The map is written for it.

  • Faults fixed first

    A misfire or a warning light is a repair, not a tuning job. Tell us and the workshop looks first.

  • Final parts fitted

    Exhaust, baffle and air filter as you will ride it. Change them later and the map is off again.

Questions

What riders ask before booking

All questions
Where can I dyno a motorcycle in Phuket?

At the Phuket Garage workshop in Kamala (41/11 Soi The Bell, Moo 5). Dyno runs and ECU tuning are by appointment, every day between 08:00 and 20:00. Message us on WhatsApp with your bike and we give you a slot.

What does an ECU remap actually change?

It rewrites the tables inside your bike’s own ECU: how much fuel is injected, when the spark fires, how the throttle butterflies follow your wrist, and settings such as rev limiters and fan temperature. No extra box is added to the bike.

How much power will I gain?

It depends on the bike and what has been done to it. A stock modern bike usually gains little at the peak and noticeably more in the mid-range and in throttle smoothness. A bike with a full exhaust on its stock map gains the most, because the map is the furthest from right. We show you the baseline before any work, so you see the real difference on paper.

Is the remap reversible?

Yes. Before changing anything we read your original ECU file and keep it. It can be written back at any time — before a sale or a dealer visit.

Which bikes can you tune?

Most fuel-injected big bikes from Honda, Yamaha, Kawasaki, Suzuki, BMW, Ducati, Triumph, KTM and Husqvarna. Support depends on the exact model, year and ECU, so send us those three things and we confirm before you book.

How long does it take?

A power run takes about an hour. A custom remap takes from half a day to a full day, longer if the ECU has to come off the bike for bench work or if the engine is heavily modified.

Where

Kamala, on Phuket’s west coast

Workshop

41/11 Soi The Bell, Moo 5, Kamala
Kathu, Phuket 83150
Hours
Daily 08:00–20:00, by appointment
WhatsApp
+66 80 681 6753

The dyno stands in the Phuket Garage big-bike workshop in Kamala, on the west coast between Patong and Bang Tao. Anything the bike needs before it can be run is fixed next door.

Open in Google Maps

Booking

Send us the bike, the year and what is fitted.

We check that your ECU is supported, tell you which tool it needs and what it costs, then give you a slot.

WhatsApp +66 80 681 6753 LINE @phuketgarage

Daily 08:00–20:00, by appointment

Book a dyno slot